The HEX ezCan for the R1300GS with spotlight, horn and rear light wiring
The ezCAN plugs directly into your motorcycle and listens to the CAN-bus.
The best plug and play solution to add accessories to your motorcycle without the need to cut any wires that could void your warranty.
The power to manage your accessories safely, customise your bike and make it safer to ride
Features:
• One device manages everything
• Integrated control by operating your accessories via your motorcycle factory controls
• Integrates additional safety features
• Does not void warranty
• Plugs directly into CAN-Bus (saves installation time and wiring complexity)
• Unobtrusive – fits perfectly under the seat
• Easy configuration of software via USB - Mac and Windows PC
• Four individually electronically fused channels, means you don't need to keep as range of physical fuses
• Waterproof and dust-proof
These channels can power:
• Left and right auxiliary driving lights
• A high-power horn
• An auxiliary brake light
• Any 12-volt accessory
Features:
• Simple downloadable software for configuration changes – down load at www. http://hexezcan.com/software/
• Independent control of left and right auxiliary driving lights
• Separate settings for daylight and night time running (based on the CAN-Bus-derived light sensor)
• Modulated brake light
• No need for a separate relay for a high-power horn
• New 3-wire dimming control for DENALI and other lights with data-driven dimming circuits
• Retains 2-wire dimming capability
• Auxiliary 12-volt switched output
• Waterproof and dust-proof
• Single switch control of devices
• Enables additional safety features
• Will not void warranty
• Plugs into and is compatible with existing CAN-Bus system
• Configurable via USB with Mac and PC software
• 4 output channels with fuse protection
• Waterproof micro USB connector
• Battery connection with fuse
• 2 CAN-Bus connectors for in line connecting
• 2 high power outputs (10A continuous / 25A max for 20 seconds)
• 2 low power outputs (4A continuous)
• Device measures 2.2in long by 1.2in wide by 0.6in thick
Included with the HEX ezCan is the following:
• HEX ezCAN device
• Micro USB cable
• 2 x Velcro strips
• 2 x blanking plugs
• 4 x cable ties
• 4 x Terminal wires (Orange)
• 4 x Blanking seals
• FREE ADVENTURE SLEEVE – usual price £9.60
Included in the wiring kit is the following:
• Four extension wires
• 1m cable that can be trimmed to the correct length
• Female connectors with terminals and seals are provided so that they can be used when cable is trimmed to length
• Male connectors to be used on your auxiliary lights and wires to your accessories
• Heat-shrink to finish off sheath when cable is trimmed
• Sheathing for finishing of wiring on the light side
• You can also connect the output stubs to the extension cable to wire up your aux lights
Fits:
R1300GS
