5 Way fused power block complete with self-healing fuses. By connecting your accessories through the 5 way fused relay output, it is impossible for any of them to draw current from the battery when the bike ignition is switched off.
If you connect accessories direct to your battery, one day you'll forget to turn the device off and come back to a drained battery. This clever little box contains a relay that takes a signal from a switched live (a wire that is live only when the key is turned to the on position e.g. your tail-light wire), and supplies power to the 5 outputs only when the key is turned to the on position. The fuse box has 5 outputs, rated at 5A, 5A, 5A, 5A, 1A.
But the really clever part is that each individual output is protected by an auto-resetting fuse.
The fuses used are self-healing. In the event of an electrical short-circuit in your accessory circuit, the individual output with the short-circuit will shut itself down. Instead of you needing to replace a fuse, simply fix the short-circuit, turn the key off, and on again and the fuse will have automatically repaired itself and all outlets will be powered up. If the short is still present, the circuit will simply shut down again.
To install it on your bike, remove the lid, connect the battery, your switched wire, and your accessories to the connectors, replace the lid and test that everything is ok
The fuse box is 60mm x 55mm x 35mm.
o * Easy to install
o * Built in relay
o * Automatically self-healing fuses
o * Compact (60mm x 55mm x 35mm)
o * No crimping or soldering required
o * 5 fused circuits 5A, 5A, 5A, 5A, 1A
o * Protects your bike wiring loom and battery from short circuits
The 3 way connector should be wired as follows:
12V : connect directly to battery “+” Terminal
Switched : connect to an output that is live when the ignition is on (the tail light is a good example of this on bikes where the lights are always on)
0V : connect directly to battery “–” Terminal
Note: Connecting 12V & 0V the wrong way round will cause permanent damage.
The 6 way connector is wired as follows:
5A : 12V switched outlet for your accessory - can provide up to 5A continuously (There are 4 x 5A Outputs)
1A : 12V switched outlet for your accessory - can provide up to 1A continuously (There is 1 x 1A Outputs)
0V : Ground connection for accessories.
Connect the positive lead on your accessories to a spare outlet terminal.
Connect the negative lead on your accessories to either the 0V connection on the 6 way connector, or else directly to the battery “–” Terminal
The 5A outlets are suitable for a heated jacket or a pair of led spot or fog lamps
The 1A outlet is suitable for a sat nav, or a USB charging outlet
By connecting your accessories through the 5 way fused relay output, it is impossible for any of them to draw current from the battery when the bike ignition is switched off.