AUTOSWITCH (AS7 VERSION)
£20.00
inc VAT
Part No: AUT-AS7
Please complete the following information, including answering the security question at the bottom. This is required to prevent spam.
Moto Abruzzo on 30 Mar 2012
Bike Owned: Aprilia Caponord Rally-Raid
Town: Civitaquana
Country: Italy
Excellent piece of kit, neat and simple to install. Works a treat with traditional (non-BMW) electrics.
G BUSH on 29 Nov 2011
Bike Owned: R1200gs
Town: Dereham
Country: United Kingdom
Great product, works really well.
For the newest BMW motorcycles with CAN-BUS technology. Now use the turn signal cancel button (TSC) on your R or K series from 2004 onwards
Already proven performance for R and K series bikes. See R1200GS installation (cut and paste this link):
http://autoswitch.com/2006/models/as6b/r1200gs_index.shtml
and the K1200GT installation: (cut and paste this link):
http://autoswitch.com/2006/models/as6b/k1200gt_index.shtml
Now featuring always ON red LED to tell you the spotlights are OFF. LED goes green when your spotlights or other accessory are ON.
Supplied with full instructions including wiring diagram.
Fits:
R1200GS
R1200GS (mark2) '08 on
R1200Adventure
R1200Adventure (mark2) '08 on
R1200RT
K1200GT
F800GS
BUT also suitable for all older BMW models
And most other models with the Can-Bus wiring system.
Technical Information
·Housing Dimensions: 1.42" square, 0.315" thick
·Weight packaged: 0.244 Lb
·Wire type: #20 600V rated
·Relay Current Info: Max current draw for Autoswitch trigger wire (violet) is 200mA @12Volts With 150mA preffered maximum.
·Weight installed with wires: 0.202 Lb
·Wire lengths: Power feed, 24" Sense wire yellow 36"
·Package includes: 3 8" tie wraps, 6 4" tie wraps, 2 wire clips, adhesive tape, instructions
How It Works
The visual LED blinks rapidly during the timed "window" up to 10 seconds long when you should release the trigger signal (high beam switch). The single tap to flash the high beams or leaving the high beams on will not activate the Autoswitch. LED shines green to indicate power to your auxiliary lights relay.
Wiring
No information is currently provided.
Installation
The Autoswitch is easy to install. If you already have auxiliary driving lights installed with a controlling toggle switch and relay, Put the Autoswitch VIOLET wire where your toggle switch was connected on the relay coil pin. Tap the RED into any ignition-swtiched 'ON' wire for power, YELLOW wire to the high beam bulb wire. Add connection to ground, and neatly tuck the Autoswitch and wires out of the way in any convenient location. And without building a bracket, drilling any holes, or modifying your dash, you're done!
SEE HERE FOR FULL INSTRUCTIONS:
http://www.autoswitch.com/downloads/as7/directions-as7.pdf
Copy and paste into your brouser